How to Fix Samsung Galaxy Showing 'No SIM Card' After Update

A Samsung Galaxy showing “No SIM Card” after an update is usually caused by a temporary network reset issue, outdated carrier settings, SIM tray misalignment, or software corruption. The fastest fixes are restarting the phone, reseating the SIM card, resetting network settings, and checking for a follow-up software update.

Steps

Restart the Galaxy phone and enable Airplane mode for 30 seconds.

A fresh radio reset often clears a temporary samsung no sim card error after a system update.
Power off the phone and remove the SIM card tray.

Check for dust, tray damage, or a shifted SIM card. Reinsert the SIM card firmly and restart the device.
Reset network settings from Settings.

Open General management > Reset > Reset network settings. Saved Wi-Fi and Bluetooth connections will be removed, but mobile network detection often returns.
Install any pending software or carrier updates.

A galaxy sim not detected update issue may be fixed by a small patch released after the main update.
Test the SIM card in another phone, or test another SIM card in the Galaxy phone.

A SIM swap check separates a phone-side fault from a carrier or SIM card problem.

Common Issues and Fixes

Issue	Likely Cause	Fix	Considerations
Phone says “No SIM Card” only after update	Modem or carrier profile mismatch	Reset network settings and install the latest patch	Often appears right after a major firmware update
SIM card works intermittently	Tray movement or poor contact after reinsertion	Reseat the SIM carefully and inspect the tray edges	Dust or slight tray warping can break contact
No mobile signal even though SIM is detected	APN or network registration issue	Check carrier settings and manually select the mobile network	The SIM reader may be fine even if service is unavailable
SIM card not detected in one phone only	Software bug or damaged SIM reader	Test Safe Mode, then back up data and consider factory reset	Use reset only if the problem started after the update
SIM fails in multiple phones	Damaged or deactivated SIM card	Request a replacement SIM from the carrier	This usually points away from a phone hardware issue

Quick Tips

eSIM models: eSIM models can show a sim error fix scenario even without a physical card. Disable and re-enable the eSIM profile first.
Dual SIM models: Dual SIM models may detect only one line after an update. Check SIM manager and confirm the correct SIM slot is enabled.
Factory reset: A factory reset should be treated as a last step. Hardware failure will not be fixed by wiping the phone.
Physical damage: Water exposure or tray pin damage can cause delayed SIM reader problems that appear after an update but are unrelated to software.

🤔Note:

If the SIM is detected sometimes but drops out later, the issue may be physical contact inside the tray or reader rather than the update itself.

💡Protip:

After reinstalling the SIM, wait a minute before testing signal bars or mobile data, since carrier registration can take longer right after a reboot.

Why did the Samsung phone lose SIM detection after an update?

A firmware update can reset network components, change carrier configuration, or expose an existing SIM tray or reader problem. The update is often the trigger, not always the root cause.

When is repair needed for a Samsung no sim card error?

Repair is usually needed when multiple working SIM cards fail in the same phone, or when the SIM tray and reader show physical damage. Repeated failure after reset steps often points to hardware.

Try It Online Try It Online Try It Online Try It Online Try It Free Try It Free Try It Free Try It Free